Posts: 7,421
Threads: 1
Joined: Sep 2005
(12-28-2017, 08:48 PM)Azryael Wrote: Well, I gave it a shot. All glued up and now to let it set for a while. Fingers crossed!
The laminating process was actually a lot of fun; I really enjoyed it.
Show us some photos.
What thickness did you use for the strips?
No animals were injured or killed in the production of this post.
Posts: 24,158
Threads: 2
Joined: Sep 2003
Location: Missouri
(12-28-2017, 08:48 PM)Azryael Wrote: Well, I gave it a shot. All glued up and now to let it set for a while. Fingers crossed!
The laminating process was actually a lot of fun; I really enjoyed it.
Hopefully, these armchair woodworkers have guided you ok.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 10
Threads: 0
Joined: Dec 2017
I cut some 1x6's in half safely, and planed each half down to 1/8"
Worked like a charm on that front.
The lamination process went relatively well for it being my first time; wish I'd used Titebond from a can instead of the bottle, but that's all I had on-hand. There was a section that somehow shifted slightly, so I'll have to sand down the side where the bottom layers overhang.
After I do all that, I'll happily get some photos up! For the next time, I need to have even more patience, but it was cold and wet and I wanted to go back inside where it was warm.
Well, before I get to any of that, I need to finish my transmission swap in my pickup.
Posts: 24,158
Threads: 2
Joined: Sep 2003
Location: Missouri
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 431
Threads: 0
Joined: Dec 2011
I have done this before by using a segmented arch, a good number of segments (6 or 8) gives a pretty good grain flow. To strengthen the end-grain glue joints, do at least two segmented halves and offset the glue lines by 50% and glue the two arches together. Then bandsaw the shape out. This allows you to make the arch as high as you want and also the shape to conform to the likely uneven arch.
My 2 cents.
