09-02-2019, 04:38 PM
(09-02-2019, 11:28 AM)C. in Indy Wrote: Aside from the overall necessity question....
If you're making a box/drawer with full dovetails, and you want to accommodate stopped grooves inside, the rabbeting trick is great.
Chris
Thank you for that piece of information. I am just thinking here, that would hid the grooves but it would change the length of the pin board. I am just considering through dovetails with an applied front but it would work without an applied front if one wanted to use part of the dovetails as a focal point. I will have to play with this idea. Probably would have never considered it on my own.
Thanks again.
Tom