10-27-2021, 12:40 PM
Rather than hijack the other thread...
Back in the distance...
Special cabinet....frame saw is on the door ....needs the 2 hangers to be rotated up to lock the saw in place...
To open the door, that latch needs to be unlocked...so..
Circled item is just a prop to hold the door open...There are 17 saws sitting in here, counting the 3 on the inside of the door.
Door latches close tight enough that no dust gets inside. Saws still look as good as new...The one saw that is standing up on it's handle? Horn is too large to fit the other way...
I do have a ready rack....on the outside of the tool chest....has a small selection of saws, easier to get at. 1 Rip, 1 full length Cross cut, 1 20" crosscut, and an Atkins No. 10
Hmmm, I might have too many saw?
Back in the distance...
Special cabinet....frame saw is on the door ....needs the 2 hangers to be rotated up to lock the saw in place...
To open the door, that latch needs to be unlocked...so..
Circled item is just a prop to hold the door open...There are 17 saws sitting in here, counting the 3 on the inside of the door.
Door latches close tight enough that no dust gets inside. Saws still look as good as new...The one saw that is standing up on it's handle? Horn is too large to fit the other way...
I do have a ready rack....on the outside of the tool chest....has a small selection of saws, easier to get at. 1 Rip, 1 full length Cross cut, 1 20" crosscut, and an Atkins No. 10
Hmmm, I might have too many saw?
Show me a picture, I'll build a project from that