Posts: 2,565
Threads: 0
Joined: Mar 2001
I am going to cut a chamfer on a 3/4 inch thick cherry board. The board is about 40 inches long.
I have a left tilting table saw with a good blade, and I have a Router Table and a brand new chamfer bit, but not a good brand. It was in a set of 20 that I picked up.
The edge will be very visible on the piece so I need it to be straight, clean, and not burned.
How would you do it? I've never cut a chamfer on the table saw before but it seems like it might be the better choice.
Posts: 2,393
Threads: 0
Joined: Jul 2005
This works for me ....
Posts: 20,381
Threads: 4
Joined: Sep 2007
Location: CinDay
Purpose of the chamfer? How big a chamfer do you plan?
I ask because the same word is used for "breaking and edge" which can be quickly, uniformly, and easily done with a block plane, a rasp, or a file. They can also be a defined edge which is a larger look.
If it is the defined edge I use the size of the piece to decide how I do it. I separate things into, is it easier to bring the work to the tool (smaller items) or bring the tool to the work (larger items) In this case TS for smaller, easier to handle items, and a hand held router for items that are larger, and would be cumbersome to drag over and onto the TS.
Worst thing they can do is cook ya and eat ya
GW
Posts: 2,565
Threads: 0
Joined: Mar 2001
The chamfer will be pretty significant meaning that on a 3/4 inch board it will take off about 1/2" leaving 1/4" on the top of the board. So a big cut which caused me to question my usual approach which would be the router table and chamfer bit.
Posts: 1,808
Threads: 0
Joined: Dec 2000
I'd take a couple of passes with the chamfer bit on the router table.
Gary
Living under the radar, heading for "off the grid."
Posts: 324
Threads: 0
Joined: Mar 2011
Location: Athens, OH
Posts: 12,909
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
I would use a handheld router because that allows me to use a climb cut, which avoids tear out. Can't do that safely at the router table.
John
Posts: 20,381
Threads: 4
Joined: Sep 2007
Location: CinDay
^^^^^^^^
This
If you use the cheap bit or not I would figure in how much work will you do before routing, and how nice a piece do you want this to be? You could snag a Whiteside chamfer bit for less than 30 bux easy from
Brian in sunny FL
Worst thing they can do is cook ya and eat ya
GW
Posts: 925
Threads: 0
Joined: Jan 2013
Location: Columbia, SC
If you're going to climb cut this chamfer, do it in several passes. You might find the router hard to control if you try to take that much material in one pass.
Posts: 281
Threads: 0
Joined: Jul 2010
Draw a line parallel to the top edge with a pencil.
With a sharp block plane, following the grain of the board, take light passes until you reach the desired line.
