Posts: 2,115
Threads: 0
Joined: Apr 2005
I have the Griz 513 extreme with a 1/2" blade. When I try to resaw some QS red oak, it will not track. Not even remotely. If I try to do it free hand, ie without the fence, the blade belles out to the right and through the piece. With the fence, the drift angle is beyond the fence drift settings, like more than 5 degrees. It starts out OK the cuts a wedge instead of a parallel slice. Everything is aligned for tracking.
Is the blade dead?? Thanks, Tom
Posts: 29,152
Threads: 1
Joined: Aug 2002
Is the blade dead??
could be. how much use has it seen? what brand is it?
Could also be under tensioned (a fairly common occurrence)
don't believe the tensioner on the back of the saw, they tend to lie, and I would skip the flutter method as well.
You need more tension not more ways to prove you do not have enough
Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
Posts: 762
Threads: 0
Joined: Oct 2007
I have the same problem after installing a brand new Timberwolf blade. No matter what I do it will not cut straight. I contacted PS Wood Machine and they told me it's most likely I bought a faulty blade. They replace it free of charge.
Posts: 2,115
Threads: 0
Joined: Apr 2005
Where are folks getting their blades these days?? Thanks, Tom
Posts: 29,152
Threads: 1
Joined: Aug 2002
woodcraft bands.... Lenox and Starret brand blades which are as good as you can buy
you will have to call the 800 number and talk to an actual person who will assist you if you want information.
Except on Fridays he takes that day off
Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
Posts: 762
Threads: 0
Joined: Oct 2007
I got the Timberwolf at Woodcraft. Then I mail order some at bandsawblades.com.
Posts: 20,381
Threads: 4
Joined: Sep 2007
Location: CinDay
Call 888-778-WOOD talk to him about your saw, and what you want to do. He'll get you fixed up.
Or go to
this page and a "have a question" balloon will pop up. No charge for free advice......
Worst thing they can do is cook ya and eat ya
GW
Posts: 151
Threads: 0
Joined: Sep 2005
Steve N said:
Call 888-778-WOOD talk to him about your saw, and what you want to do. He'll get you fixed up.
Or go to
this page and a "have a question" balloon will pop up. No charge for free advice......
+1 on Cyber Woodworking Depot. Great blades and great advice.
Posts: 12,874
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
What kind of blade? Resawing requires a blade with very few teeth, like 3 or 4 for a 1/2" blade. Drift is caused by a blade that's not positioned properly on the wheels or wheels that aren't close to co-planer, a blade that doesn't have equal set on both sides, or is dull on one side. A belly in the blade could be due to too little tension, or most of what I said above.
John
Posts: 3,545
Threads: 1
Joined: May 2004
Location: Wisconsin
The blade may not be dead, but it's likely dead for resawing unless resharpened. A bandsaw blade used for resawing needs to be sharper than one used to cut thinner materials, as explained
here. He also shows why tension helps.