08-25-2016, 12:26 AM
Hi All,
I thought I would pass along my happy experience with a particular stain. I am concerned about a panel shrinking a bit in the winter and showing the non-stained portion of a panel.
So, I stain the edge of a panel, then glue up and then stain the whole panel. It works only with oil based stains, obviously. The results I get with the "General" company's stain are very excellent. No lap marks, and no two tone issues. Below is an example.
- Joe
![[Image: Pre%20Stain_zps65ldxhwg.jpg]](http://i1098.photobucket.com/albums/g372/rcplaneflyer/Pre%20Stain_zps65ldxhwg.jpg)
![[Image: After%20Stain_zpsuhwdk1hx.jpg]](http://i1098.photobucket.com/albums/g372/rcplaneflyer/After%20Stain_zpsuhwdk1hx.jpg)
I thought I would pass along my happy experience with a particular stain. I am concerned about a panel shrinking a bit in the winter and showing the non-stained portion of a panel.
So, I stain the edge of a panel, then glue up and then stain the whole panel. It works only with oil based stains, obviously. The results I get with the "General" company's stain are very excellent. No lap marks, and no two tone issues. Below is an example.
- Joe