Posts: 1,393
Threads: 24
Joined: Aug 2001
Hi Fellas,
Been a while since I've been on this board. (The password reset thing wasn't working, so I created a new registration).
Anywho, I think I overload the Unisaw I acquired last year and it won't turn on.
I'm guessing it is a 970s model, but that's a guess.
Where is the reset button on this beast? thanks!
Posts: 5,661
Threads: 1
Joined: Mar 2008
Location: Flemington, New Jersey
1. I have no idea.
2. Good to see you back!
3. Ag
Posts: 5,186
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
Wild guess, on the motor?
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 1,998
Threads: 1
Joined: Aug 2016
05-10-2017, 08:12 PM
(This post was last modified: 05-10-2017, 08:12 PM by Roly.)
If it has a magnetic starter the overloads are on the contactor, not in the motor. Unplug remove cover on starter and look for a reset button , do not adjust the setting but the reset will be close. Roly
Posts: 10,777
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
If the saw has low voltage controls, inside the big box on the back of the saw, its the red button.
Ed
Posts: 3,156
Threads: 1
Joined: Jan 2005
Location: Northern Ohio
Push the OFF button to its full depth.
That's how I reset my 1994 Unisaw with 3hp motor and magnetic switch.
Mike
Posts: 1,393
Threads: 24
Joined: Aug 2001
Silly me....I looked at the back of the saw (I built an extension table off the back, so it was tough to see) and guess what I found???
Yup, the reset button.
Some things never change, eh?
Posts: 676
Threads: 2
Joined: Jan 2007
05-11-2017, 08:37 PM
(This post was last modified: 05-11-2017, 08:37 PM by cvillewood.)
What's your handle again? ;-)
Posts: 20,381
Threads: 4
Joined: Sep 2007
Location: CinDay
Funny, not too neighborly, but still funny. Welcome back Polack.
Worst thing they can do is cook ya and eat ya
GW
