What finish to use on a hammer handle??
#15
Tru-Oil.
Best,
Aram, always learning

"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery


Web: My woodworking photo site
Reply
#16
(02-15-2018, 02:59 PM)s9plus20 Wrote: Thanks for all the suggestions!

I finished them off with a coat of BLO. They turned out great!

Frankie



Cool
Cool
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#17
The Purdy paint brushes I prefer have raw wood handles.  I dip the handles in Sealcoat and after a few minutes I wipe the excess off the tip of the handle so I don't end up with a glob there.  An hour later I repeat.  

It does not get sweat, as I am gloved when I paint, but it cleans up better and looks a lot nicer.  Easy application, I don't even have to pour the Sealcoat into a pail, I just dip in the can.
No animals were injured or killed in the production of this post.
Reply
#18
For gits and shiggles, wipe a bit of Dexron ATF on a bit of scrap next time you're doing some vehicle maintenance.
Blackhat

Bad experiences come from poor decisions. So do good stories. 


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.