Broken bandsaw blade repair?

[Bob Vaughan]

I tried SS and just couldn't get it to stay.  I watched a video on using a tig welder.  I will try that next.

You could try it this way
http://owwm.org/viewtopic.php?t=33506

That 142" blade would work nicely on a vintage Delta 28-350 20" band saw.

[Timberwolf]

You could try it this way
http://owwm.org/viewtopic.php?t=33506

That 142" blade would work nicely on a vintage Delta 28-350 20" band saw.

.............................
Good pics....I would just add that a "poker" can come in handy when dealing with really small blades...I just make one out of steel wire...clean and flux the tip and use it to "pick up" a small amount of molten solder and deposit it on the heated and fluxed joint..properly done, it will leave a clean joint that requires very little "dressing'.....