Posts: 36,547
Threads: 3
Joined: Nov 2004
Location: RTP, NC
(03-16-2021, 10:51 AM)chrisntam Wrote: Wood glue or construction adhesive?
And thank you for all the advice, it is appreciated!
FTR, it's on a short hip, I don't think there will be much jacking force needed to bring it back in line.
chris.
Construction adhesive. I was putting walls in a basement and gluing the sill plates down. I framing the walls flat and standing them up. One had a door in it. I left the sill plate whole so the bottom wouldn't twist while I was putting it up. I would cut that section out later. I forgot and glued the area in the doorway also. The 2x4 failed before the glue did.
Posts: 1,937
Threads: 0
Joined: Feb 2008
All good advice. As for the angle cut; just mark a plumb cut with your speed square or framing square. Set your saw to 45* bevel. In a perfect world it would fit perfectly, so adjust to fit.
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Posts: 2,716
Threads: 0
Joined: Mar 2001
Location: Los Angeles
It’s probably way overkill but I would sandwich a strip of plywood between the rafter and the lumber you are sistering. I’d vote for some glue as part of the sandwich. Construction glue is amazingly strong.
Posts: 6,518
Threads: 0
Joined: Dec 2003
Location: Dallas, Texas
I repaired it this morning, 2x6 on each side, construction adhesive and structural screws. The sag is gone.
Thank you for the advice.
chris.
