Posts: 36,546
Threads: 3
Joined: Nov 2004
Location: RTP, NC
I need to change the Main belt on a walk behind mower. I need to get the bolt out of the engine shaft. A wrench just spins the engine. I can try clamping the operator handles to lock the engine to the wheels but there is no way to put this in the equivalent of in gear but also in park like a rider. The only other thing I can think of is a clamp on the pulley. I have an electric impact wrench so will use that also. Other suggestions?
Posts: 527
Threads: 0
Joined: Feb 2021
Location: Stevi, Montana
Ok, dumb question time. Is there a flat on the shaft you can get a wrench on?
Our rider has flats on the pulley shaft, I broke a pulley drive assembly and had to replace, the shaft had a place for a wrench.
I would hesitate with a clamp on the pulley as it could deform or possibly crack...
Posts: 36,546
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Not a dumb question. I don’t know. I’ll check more thoroughly later today
Posts: 22,712
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
First thing I would likely try is to use the belt like it was a strap wrench. Wearing a glove, put the belt around that pulley and gather it in your fist as tight as you can. Turn your wrist tighten against the pulley and apply socket to bolt.
Blackhat
Bad experiences come from poor decisions. So do good stories.
Posts: 12,606
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
What blackhat said, put use your impact wrench. The hammering should break it loose fairly easily.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 892
Threads: 0
Joined: Apr 2006
Location: Trout Creek, Montana
Very common on a spinning shaft is left hand threads. Other than that I am no help.
Treat others as you want to be treated.
“You only live once, but if you do it right, once is enough.” — Mae West.
24- year cancer survivor
Posts: 12,885
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
Hold or block the blade. The bolt is probably threaded opposite the direction of rotation of the blade, so you would remove it by turning the wrench in the same direction the blade spins.
John
Posts: 94
Threads: 0
Joined: Jun 2003
If the impact wrench doesn't work, take the spark plug out and push some nylon rope in. When the piston comes up it will hit the rope and not be able to travel any further. The bolt should be standard right hand threads.
shifty
Posts: 36,546
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Thanks for all the replies. Something was bugging me after I posted this. I looked at the parts diagram for this mower, then looked more thoroughly at the mower, and with a better light. The bracket that holds the belt on is not bolted through the main shaft bolt. It sits just forward of center on the pulley and is bolted to the mower chassis. So I did not have to remove the main shaft bolt to get that bracket off.
