Posts: 374
Threads: 0
Joined: Oct 2005
My cherry kitchen cabinets were finished with Minwax Polyurethane spray...satin.... They have accumulated oil and grease from daily use (especially over the stove). How do I clean the doors without stripping and re-spraying? In the past I tried denatured alcohol with 4/0 steel wool, but that resulted in a re-spray. If I can get the grease/ oil off, I can decide what to do then.
Posts: 31
Threads: 0
Joined: Feb 2021
TSP works real good
(tri sodium phosphate)
Posts: 12,919
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(12-07-2021, 09:05 AM)jcclark Wrote: TSP works real good
(tri sodium phosphate)
That can easily result in damaging the finish. I would start with simple Dawn dish soap in warm water. If you have really greasy areas then test some mineral spirits where it won't show and if it shows no damage to the finish then wipe those areas with mineral spirits. In both cases, you need to rinse the sponge or changed the paper towel frequently, and probably go over each area multiple times to really remove the grease and not just smear it around.
John
Posts: 2,213
Threads: 1
Joined: Sep 2003
Location: Maryland
12-07-2021, 10:31 AM
(This post was last modified: 12-07-2021, 12:43 PM by joe1086.)
(12-07-2021, 10:17 AM)jteneyck Wrote: That can easily result in damaging the finish. I would start with simple Dawn dish soap in warm water. If you have really greasy areas then test some mineral spirits where it won't show and if it shows no damage to the finish then wipe those areas with mineral spirits. In both cases, you need to rinse the sponge or changed the paper towel frequently, and probably go over each area multiple times to really remove the grease and not just smear it around.
John
^^^^^THIS^^^^^
Dawn should work. Don't let the sponge get so wet that water gets into the panel grooves. We wipe the hood and cabinets near the stove down every few months so the job doesn't get too bad.
Posts: 2,002
Threads: 1
Joined: Aug 2016
(12-07-2021, 10:17 AM)jteneyck Wrote: That can easily result in damaging the finish. I would start with simple Dawn dish soap in warm water. If you have really greasy areas then test some mineral spirits where it won't show and if it shows no damage to the finish then wipe those areas with mineral spirits. In both cases, you need to rinse the sponge or changed the paper towel frequently, and probably go over each area multiple times to really remove the grease and not just smear it around.
John
*This again* Roly
