02-24-2022, 03:42 PM
Was getting a bit out of hand....decided to sort through the mess...stuff that should have been tossed long ago, was...which left..
And a "chunky" one...
Might get a few parts from it? Resaw on the tablesaw, except for these..
Digging around found these 5...lids and box bottoms?
Ok, set up to resaw the rest of the mess to ~ 1/2" thick....trying to get the "better" stuff....most of the thin stuff was tossed..so..
This is what I wound up with.....started to see IF some would make a couple small boxes..
A cut here, a trim there...and maybe a fancy lid?
None of these parts are the same width....some were tapered...
A second box, maybe?
Hmm, top, or bottom?
Will see how the pile holds up...only use for these boxes is to reduce the scrap bin...
Stay tuned
And a "chunky" one...
Might get a few parts from it? Resaw on the tablesaw, except for these..
Digging around found these 5...lids and box bottoms?
Ok, set up to resaw the rest of the mess to ~ 1/2" thick....trying to get the "better" stuff....most of the thin stuff was tossed..so..
This is what I wound up with.....started to see IF some would make a couple small boxes..
A cut here, a trim there...and maybe a fancy lid?
None of these parts are the same width....some were tapered...
A second box, maybe?
Hmm, top, or bottom?
Will see how the pile holds up...only use for these boxes is to reduce the scrap bin...
Stay tuned
Show me a picture, I'll build a project from that