12-08-2022, 11:57 PM
Test fitting M&T joinery on my current build.
Semper fi,
Brad
Brad
|
Daily Bench Shot
|
 
12-10-2022, 06:04 PM
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020 
12-11-2022, 11:52 PM
Tearing up church pews or rebuilding?
Phydeaux said "Loving your enemy and doing good for those that hurt you does not preclude killing them if they make that necessary."
Phil Thien women have trouble understanding Trump's MAGA theme because they had so little involvement in making America great the first time around.
12-12-2022, 06:22 PM
(12-11-2022, 11:52 PM)Bob10 Wrote: Tearing up church pews or rebuilding? Repairing one. Some 300# gal went to move it herself and moved the end she picked up too far and twisted the other end and popped it off. 
Steve
Mo. I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24 The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints WaterlooMark 02/9/2020 
12-13-2022, 08:06 PM
12-13-2022, 08:16 PM
Building newel posts for the house we are overhauling.
The first woodwork on a huge project Also a pic of the trim for the house
12-16-2022, 02:59 AM
(12-12-2022, 06:22 PM)Stwood_ Wrote: Repairing one. Some 300# gal went to move it herself and moved the end she picked up too far and twisted the other end and popped it off. I hope she was gone before you got there
Phydeaux said "Loving your enemy and doing good for those that hurt you does not preclude killing them if they make that necessary."
Phil Thien women have trouble understanding Trump's MAGA theme because they had so little involvement in making America great the first time around. 
01-01-2023, 05:56 PM
(This post was last modified: 01-01-2023, 06:25 PM by thewalnutguy.)
Hopefully "in the kiln" qualifies as "on the bench" for this stream . Loaded up about 170 board feet of walnut that i milled about 15 years ago. It's been stickered on a rack in a pole barn, protected from the weather. Moisture meter shows it at about 14 percent, so it will have to spend a bit over a month in the kiln before it ends up on my bench where some of it will end up as drawer fronts for a Greene-and-Greene inspired dresser. Quite a bit of this lot resulted in boards 8 to 10 inches wide, and generally quite good quality with very few if any knots. The board shown standing on end is fairly typical of the material in this lot, almost 10 inches wide, a small honeycomb and small split in one end. This tree came from a friend who operates a tree service company.
01-04-2023, 08:01 PM
Nice batch of walnut
01-04-2023, 08:03 PM
Making headway on my newel posts.
Quartersawn white oak
|
|
|
Users browsing this thread: 51 Guest(s)