Posts: 105
Threads: 0
Joined: Jan 2007
(02-19-2023, 10:28 AM)servojohn Wrote: Bob,
Thanks, yes, the posted photos did not enlarge well for these bifocal peepers to read. I'll send a pm.
Best regards,
John
(02-19-2023, 01:46 PM)FrankAtl Wrote: Hi Bob
I'd like a copy of that chart too if you don't mind. I tried to send you a PM but it looks like you have it turned off.
Thanks!
Frank
Bob,
Can't find a "PM" option on your posts or at your Control Panel/Account info section here. PM me and I'll get you my email address.
Best regards,
John
Posts: 1,383
Threads: 0
Joined: Sep 2007
(02-20-2023, 08:53 AM)servojohn Wrote: Bob,
Can't find a "PM" option on your posts or at your Control Panel/Account info section here. PM me and I'll get you my email address.
Best regards,
John
I'm profoundly embarrassed. I looked at my settings and it was clear to me that I've neglected lots of details. As a result I've missed a lot over the years. Oops. Hopefully that problem has been solved. Try another PM.
Posts: 105
Threads: 0
Joined: Jan 2007
First, thanks to Bob for emailing full size images of his cutter charts.
Unfortunately, most of the ones I acquired are 42 series carbide made by Leitz.
So, changed the search strategy a bit, and found some owner's manuals for a couple of Delta's shapers from the same era that have cutter charts and parts numbers listings for associated parts like rub collars/spacers. Here's a link, charts start on page 24 I believe. The first chart is for the HSS cutters, which I also have some in this lot.
432-02-651-0018 (007).qxd (mikestools.com)
On this not so nice weather day here in northern Colorado, I'm thinking it a good time to sit down and sort thru things and match the stackable pieces with their proper mates, and then make a holder board with some dowels and a base. ;>)
Thanks again to everyone,
John
