12-13-2023, 04:14 PM
That I bought at the Tractor Fest last Labor Day...
Decided to sort through a few things...toss out the junk ones...and see IF I have the replacement Bits..
Got out the Black Box..
Opened it up..
Pull out a few Irwins...
Some of the bits needed cleaned up, BEFORE I could figure out the "Toss or Keep" part...Jennings bit, without the square, tapered end..toss. A few were too pitted from rust, a couple no longer had their spurs....
Finally..
A "full set"....4/16" up to 16/16"...found the awol sizes...replaced the trashed bits..
Then roll the canvas back up..
Roll has 2 eyelets...you can either hang by 2 hooks on a wall, all opened up and ready for use..or...
Leave it rolled up, and hang it by one hook/nail/screw...
Where it is out of the way, until called for.
Bits are now all Irwins, or made by Irwin....Cleaned up with a wire wheel on my grinder...
Price? Spent about $5....

Decided to sort through a few things...toss out the junk ones...and see IF I have the replacement Bits..
Got out the Black Box..

Opened it up..

Pull out a few Irwins...

Some of the bits needed cleaned up, BEFORE I could figure out the "Toss or Keep" part...Jennings bit, without the square, tapered end..toss. A few were too pitted from rust, a couple no longer had their spurs....
Finally..

A "full set"....4/16" up to 16/16"...found the awol sizes...replaced the trashed bits..
Then roll the canvas back up..

Roll has 2 eyelets...you can either hang by 2 hooks on a wall, all opened up and ready for use..or...

Leave it rolled up, and hang it by one hook/nail/screw...

Where it is out of the way, until called for.
Bits are now all Irwins, or made by Irwin....Cleaned up with a wire wheel on my grinder...
Price? Spent about $5....
Show me a picture, I'll build a project from that