Posts: 4,276
Threads: 0
Joined: Feb 2001
Really nice craftsmanship. I enjoyed seeing your thought process and problem solving shills at work. To do work like that it takes a lot of patience also. That one took a lot of time and doing the outside and inside work was the easy part. Nice job.
Tom
Posts: 314
Threads: 0
Joined: Feb 2012
Location: Carson Valley, NV
That's really a sharp looking table. IF.... you ever have to make it again you might try making the splines a little longer and pin them from the bottom with with a dowel in a blind hole so it wouldn't show on top. Never the less, one great looking table!
Posts: 12,912
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(06-20-2024, 07:07 PM)wood-chips Wrote: That's really a sharp looking table. IF.... you ever have to make it again you might try making the splines a little longer and pin them from the bottom with with a dowel in a blind hole so it wouldn't show on top. Never the less, one great looking table!
Thanks. That might work, but I feel a lot more confident in the three-layer ring I made. If you think about it, the middle ring is equivalent to the longest spline possible.
I'll have a good idea of its fate by next Spring.
John
