Posts: 796
Threads: 0
Joined: Feb 2005
A friend has a table that was finished with poly (she said) years ago. At some point someone put something hot on it and "melted" the finish some.
What can be done, short of refinishing it (she wants to save the patina)? The sheen is gone in that spot and you can see the texture of whatever was set there.
Rick
Any government that robs Peter to pay Paul, can always count on the support of Paul!
MAGA!!
Posts: 7,421
Threads: 1
Joined: Sep 2005
I've top coated oil based poly by lightly sanding and adding another coat. But you really don't know what kind of poly is on this do you?
If it is oil based, I would use a fine brush to build up the damaged area, sand it level and then apply another coat of poly. But you will have to test the finish to see if that will work here.
I guess you could play with mixing some finish up and applying it with a fine brush and then just polishing the whole table with automotive polishing compound.
This is not a Harris Tweed where you can take some threads from one area and re-weave it in the damaged area. I think it will be difficult to make a perfect match.
No animals were injured or killed in the production of this post.
Posts: 12,667
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
I would try Cooler's second option, with a twist. I would try to sand the damaged area smooth, without going to bare wood, and then lay in new coats of poly until that area is higher than the rest. Let it cure for at least a week, and then carefully sand it down flat with the rest. Then polish it to the same sheen as the top, doing the entire top at the end to make it all the same.
John