Measure twice, cut multiple times
#21
Did similar except too big. 

I did a kitchen for one of my daughters.  Of course corner cabinets aren't 24x24 but 36x36 - at least in this kitchen.  I had the plans and I clearly marked it 36".  After I built it I thought I put down the wrong measurement - so I changed it to 24".  So that meant the next cabinet I made 12" wider.  Got to install and realized the mistake.  I couldn't use the cabinet in that spot.  Got lucky because it could fit in another spot where there was going to be a shelf unit.  So instead of a shelf unit we put the cabinet there then extended the counter top.
John

Always use the right tool for the job.

We need to clean house.
Reply
#22
It's been my experience that the piece cut incorrectly is directly related to the cost of the wood. When I build out of pine, almost all the cuts are perfect. When I try something like bubinga or mahogany, well...….

At least I have a wood burning stove!
Jim

Demonstrating every day that enthusiasm cannot overcome a lack of talent!
Reply
#23
My first thought was add a faux drawer to the top of the doors.
Reply
#24
Recent night stand in walnut. I was building the door parts and moving along quite nicely. So nice that I drilled euro hinge cup holes in ALL the stiles
Angry Fortunately the doors weren't assembled and I only had to make two new stiles.
Reply
#25
(08-26-2019, 09:09 AM)rwe2156 Wrote: My first thought was add a faux drawer to the top of the doors.

Clever!

Simon
Reply
#26
(08-26-2019, 09:09 AM)rwe2156 Wrote: My first thought was add a faux drawer to the top of the doors.

My first thought after realizing my mistake was to try to make it an actual drawer then after thinking about how much work that was going to be on a finished cabinet I was going to make a false door as you suggested.  In the end I made the correct size doors...it took me all day but worth it in the end. 

   

   
Reply
#27
I made a corner drawer once. I decided it was way to much effort for a drawer.
Steve

Missouri






 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#28
Ya did it right Duane! Any other fix would have bugged you forever and better to drop back and make it correctly.

Wife asked me once, why I don't make mistakes. I did not answer, but truth be told, I never mention all my mistakes!
Waiting to grow up beyond being just a member
www.metaltech-pm.com
Reply
#29
(08-31-2019, 06:49 AM)Tony Z Wrote: Ya did it right Duane!  Any other fix would have bugged you forever and better to drop back and make it correctly.

Wife asked me once, why I don't make mistakes.  I did not answer, but truth be told, I never mention all my mistakes!

I guess I'mnot the only one where things like this would have bothered me because it didn't end up the way it's supposed to be.  I'm glad I re-made the doors honestly...one less thing to irk me. 
Laugh
Reply
#30
As one who has numerical dyslexia and transposes numbers -- 21 becomes 12 -- measure twice usually results in cut twice, and more.  Urr.

Question:  How did you join the rails and stiles on these doors?  Were they cope and stick or did you use dowels or tenons?  They look nice either way, full-sized or underside-sized.

Thanks!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.