Oil or shellac on assembly table?
#17
Been using BLO and paste wax as my go-to for workbench and assembly surfaces for 15 years. Glue pops right off. Wax gets refreshed every year or so.
When I was young I sought the wisdom of the ages.  Now it seems I've found the wiz-dumb of the age-ed.


Reply
#18
I really don't want wax on an assembly table that I'm assembling something of bare wood on.
Say a cabinet box. Sliding it around to turn it over. Maybe some of that wax sticks on a cabinet grade cab side that shows, and after finishing you have this mystery spot on the side of your cabinet.
You never know. If I want a slick surface, I'll use laminate.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#19
(02-07-2020, 11:54 PM)®smpr_fi_mac® Wrote: I built an outfeed/assembly table.  Top is BB plywood.  To make glue stick less, what should I put on it?  I'm thinking BLO.

I've always preferred paste wax.
WoodNET... the new safespace
Reply
#20
Howie used to say that film finishes were no good on workbenches. Once the film is cracked, the protection is lost. His favorite was 1/3 turps, 1/3 blo and 1/3 beeswax applied in as many coats as the material will take. Wipe off any excess. Not sure if an outfeed/assembly table is a workbench, although I would classify it as such.
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#21
(02-09-2020, 09:42 PM)cputnam Wrote: Howie used to say that film finishes were no good on workbenches.  Once the film is cracked, the protection is lost.  His favorite was 1/3 turps, 1/3 blo and 1/3 beeswax applied in as many coats as the material will take.  Wipe off any excess.  Not sure if an outfeed/assembly table is a workbench, although I would classify it as such.

BTW, is Howie still around?

Doug
Reply
#22
He never made it past the software switch. Other than that, I know nothing about his well being.
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.