10-21-2020, 11:49 AM
I come across unmarked sharpening stones at flea markets and estate sales. Is there an easy way to identify whether they are oil or water stones? .
sharpening stones
|
10-21-2020, 11:49 AM
I come across unmarked sharpening stones at flea markets and estate sales. Is there an easy way to identify whether they are oil or water stones? .
10-21-2020, 06:50 PM
Put a drop or two of water on the stone. If the water stays beaded it is probably an oil stone.
Thanks, Curt
----------------- "Life can only be understood backwards; but it must be lived forwards." -- Soren Kierkegaard
10-21-2020, 10:25 PM
My guess would be 99% of them are oil stones and most are probably less desirable ones. Every now and then you come across a beauty. Just my experiences....
10-22-2020, 07:39 AM
A lot of older oil stones won't work well because the oil inside the stone has cured over time. The easiest way to refresh the stone is to throw it in the dishwasher. Another method is to soak it in gasoline or some other solvent like mineral spirits. I've also seen some who use WD-40. Make sure it's an oil stone if you're going to do either of the above. If the stone isn't flat, use some sandpaper on a flat surface or a diamond stone to true it up. Even if it's already flat, it doesn't hurt to take a few swipes on the sandpaper or diamond stone to remove any residual grime. Use mineral oil or kerosene or something like that as a lubricant.
Still Learning,
Allan Hill
10-22-2020, 07:41 AM
(10-22-2020, 07:39 AM)AHill Wrote: The easiest way to refresh the stone is to throw it in the dishwasher. . . . Ha ha, if I did that I'd have the stone impaled into my forehead by my bride!!!! ![]()
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
10-22-2020, 07:54 AM
(10-22-2020, 07:41 AM)Admiral Wrote: Ha ha, if I did that I'd have the stone impaled into my forehead by my bride!!!! Rightfully so, and that would happen to me as well.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
10-22-2020, 02:38 PM
NO DISHWASHER! I learned the hard way, with an oily film on every surface! SWMBO ended up with a new appliance (it really worked well, though).
I have bought many dozens of stones at flea markets, antique malls and tool sales. The oilest stone can be cleaned, with oven cleaner the best method, scrubbed with a brillo pad and steaming hot water. What to look for? First, scrape a finger nail on the stone, to determine how fine the stone is, with natural stones the finest. Second, look for well made boxes. Craftsmen of old, generally made a fancy box for their expensive stones. I've picked up more than a dozen washitas, same number of translucent & black arkansas stones. I have been fooled a couple of times with really dirty india stones (manmade oilstones, no value), but the worse was my own fault. I saw a Norton Tri-stone hone (11" long stones), priced at $85.00. I tossed down my cash, without opening, because, well just because. When I was out of site of the tble, I opened it up, figuring to find natural oilstones. Instead were three wore out silicon carbide coarse stones, worth crap. Must have been a butchers' hone.
Waiting to grow up beyond being just a member
www.metaltech-pm.com
10-22-2020, 11:08 PM
I never ran stones through the dishwasher, but I did use our coffee grinder to break down shellac flakes. Worked great until i got cocky and kept my finger on the pulse button a little too long. SWMBO selected a nice new replacement and now pays much closer attention when I go into kitchen cabinets.
10-23-2020, 12:44 AM
(10-22-2020, 11:08 PM)RichK Wrote: I never ran stones through the dishwasher, but I did use our coffee grinder to break down shellac flakes. Worked great until i got cocky and kept my finger on the pulse button a little too long. SWMBO selected a nice new replacement and now pays much closer attention when I go into kitchen cabinets. Sonic cleaners work well. Scrubbing with Simple Green too. Afterward, whatever method, I've found it helps some to go over them with a stout shop vac. hose, seems to pull a bit from the pours. ED |
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.