Table Edge Router Bit
#8
Am making extra leaves for a 110-year-old walnut dining table. Below is a tracing of it.  Would there be a router bit like this, or will I need to figure out how to do it with a combination of bits? The top is 3/4 thick and from the sharp edge on top to the outer curve is 11/16.  Thanks.
Reply
#9
You might search at MLCS.  A quick look at their site shows the bit shown at this link:  Table edge bit
Ray
(formerly "WxMan")
Reply
#10
Probably going to need a second pass with another bit to shape the bottom of your profile.
Reply
#11
This Grizzly giant thumbnail bit would give you the main profile, and a standard roundover bit of whatever radius you like will give you the bottom. 

John
Reply
#12
Whiteside has bits for the top edge, you'll need a round over bit for the understand edge.
Reply
#13
Page 23 in the Whiteside catalog shows the thumbnail table edge bit.  You will have to add a round-over bit for the bottom edge.

https://www.slideshare.net/Western-Build...it-catalog
No animals were injured or killed in the production of this post.
Reply
#14
Thank you, everyone. The links are much appreciated.
Peter
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.