Posts: 4,676
Threads: 0
Joined: Jan 2007
Chisel out the mortise's for the hinges and raise them up.
Any free advice given is worth double price paid.
Posts: 12,046
Threads: 1,611
Joined: Jan 2001
Location: Kansas City, Kansas
Check the square of the door frame. Sounds like the opening is skewed---tilted like a trapezoid instead of a rectangle.
The only fix for that is to remove the frame and fix the framing to make a more square opening.
Posts: 1,688
Threads: 0
Joined: Oct 2001
There are latch plates with wider openings. Have you looked into them? If this is a seasonal then moving the existing plate could give you problems when the weather changes.
Mike
I work on the 50-50-90 rule: If there's a 50-50 choice, I'll pick the wrong one 90% of the time!
Posts: 64,674
Threads: 3
Joined: Feb 2007
Location: Merryland
It's rare that an exterior door sags. It's almost always something else. Like posted above. Measure the door from diagonal corner to corner to check for square. Then do the same with the frame.
What do you find?
Posts: 5,733
Threads: 2
Joined: Dec 2004
Location: Fort Worth
How much slop is there in the hinges themselves. I have seen hinges wear quite a bit. Most of your issue is probably from the frame being out if square.
Posts: 12,197
Threads: 2
Joined: Nov 1999
Location: Nebraska City
Is this a new problem? I think most of the responses assume it's a newly hung door...
Posts: 13,266
Threads: 0
Joined: Aug 2001
Location: Royersford Pa.
Since you can make it work by lifting the door, it sounds like the hinges are loose. The first thing to try is replacing the top hinge screws with 3" long screws. These will reach the stud and should pull the top of the door back raising the latch up to fit the strike.
Also replace the screws into the edge of the door with longer screws too. The old screws may be stripping out allowing the door to sag.
Twinn
Will post for food.
Posts: 21,881
Threads: 0
Joined: Oct 2003
Put a level on the hinge-side jamb.
Is it plumb?
Check the outside edge of the door.
Is it plumb?
It sounds like it's so far out that you'll have to adjust some of the hinge mortises and plane a door edge some.
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
