09-24-2015, 08:10 PM
I have a 30"x60"x2.25" thick laminated bench top that has a bow 3/32" in the center.
Is it possible to sand the bow out of it if I bring it to a local cabinet shop and run it through a Timesaver sander. I figure if it's run concave side down to flatten out the hump, then flip it to run the other side that could do it.
I want to use it for an assembly bench/outfeed table for my SuperMax. I'm building the base based on the Fine Woodworking, current issue bench.
Is it possible to sand the bow out of it if I bring it to a local cabinet shop and run it through a Timesaver sander. I figure if it's run concave side down to flatten out the hump, then flip it to run the other side that could do it.
I want to use it for an assembly bench/outfeed table for my SuperMax. I'm building the base based on the Fine Woodworking, current issue bench.
Gary
Living under the radar, heading for "off the grid."
Living under the radar, heading for "off the grid."