10-23-2015, 10:58 AM
Rarely use this tool. Putting on some crown moulding. About 2 out of 3 times, a nail does not come out. Of course, puts a dent in the moulding so have to patch it.
Looked at some You-Tube videos, took the thing apart. With a brief look, none of the seals were broken and the inside seemed well lubricated. Any ideas how to remedy this?
Looked at some You-Tube videos, took the thing apart. With a brief look, none of the seals were broken and the inside seemed well lubricated. Any ideas how to remedy this?