I thought everyone would love to have one

[Arlin Eastman]

Bob sells vacuum chucks at a really great price and all you have to do is put a few things together.

http://www.frugalvacuumchuck.com/

He is an wonderful guy and makes great stuff and I thought everyone would like to know where to buy it hundreds cheaper.

Arlin

[Bob Bergstrom]

We have one at our woodturnig workshop and at least three members with them. They work very well. We rebuilt a one that was low ( pretty easy to do). It pulled over 26 inches. I have a Gast that I paid $450 for before these became available. A real plus is because they are piston driven is they will hold vacuum for about 10 seconds even with the power shut off. I have seen Bobs Demo twice and he is a great person with a desire to just help others enjoy turning.

[Steve K]

Arlin Eastman said:

---

Bob sells vacuum chucks at a really great price and all you have to do is put a few things together.

http://www.frugalvacuumchuck.com/

He is an wonderful guy and makes great stuff and I thought everyone would like to know where to buy it hundreds cheaper.

Arlin

---

Thanks Arlin
I already have a vacuum pump, one I built with a Joe woodworker kit. Recently I bought a venturi set up I'm going to dedicate to the lathe and I can make the chucks basically from what I have on hand.

[Bucko]

Thanks so much for the post, I've been borderline on getting a Vac setup and it looks like if I'm going to do it this is the way to go.

[Bucko]

I did it and purchased, a couple of questions answered by Bob were helpfull. My unit is on the way and will be most welcomed.

[Arlin Eastman]

Yah he is a swell guy.

Glad I could help.

Arlin

[iclark]

A bump and a couple of questions:
1) Does anyone have any recent experience with this vendor? Somehow, I missed seeing them in the Pittsburgh vendors area.

2) What is the difference between the "Parts Kit" included with the Frugal and Better and the "Small Parts Kit" included with the Best?

[Arlin Eastman]

Now all he sells is the good and best pumps. I bought mine from him and we still send emails back and forth and he is a great guy.

For me he even put everything together including the upright boards and hoses and all I had to do is flip the switch.

It is a wonder to use but I do not know how to make a smaller chuck. He makes them for all sizes of headstocks and you will have to tell him what lathe you have.

For the muffler I packed a white rage into the pvc and then put end caps onto the pvc but drilled a 1" hole to let the exhaust escape.

You can ask him any questions you wish and he always has time to answer.

Arlin