Posts: 4,911
Threads: 3
Joined: Apr 2009
I have the LV as well as a bunch of vintage Stanleys and the LV is really, really nice. I think the closed throat would be better for the jobs you mentioned. I have not used the LN, but I can't imagine that it isn't also a high quality tool and its a little less expensive than the LV.
Currently a smarta$$ but hoping to one day graduate to wisea$$
Posts: 10,706
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
Cleaning up dados, grooves, and rabbets in ply is a hit and miss operation, since it's so easy to lift up one of the intermediate plys if the exposed ply is cut really thin. I have the LV large router. The LV also offers many different sizes of cutters, vs. the LN one which is basically just one cutter. For hinge mortises, the large router is often too large. You may consider getting both a large router and a small one. The smaller router will more easy to control and span shorter distances. The opening on a large router may not allow you to keep the entire base of the router across your hinge mortise, requiring you to create a spacer at the same height as your work piece. This is especially true if your mortise is close to the end of the board.
Still Learning,
Allan Hill
Posts: 2,380
Threads: 0
Joined: Dec 2011
ruffcutt said:
I'm thinking of getting a router plane. I don't know which brand and if I want an open throat or a closed throat plane.
My main use would be to clean up the bottoms of table saw made dadoes in plywood to insure a consistent depth. Secondary use would be for cleaning up the bottoms of hinge mortises.
As far as brands go I like good tools so I'll pay for a good one.
You didn't say how you cut the hinge mortises. If by a power tool as well, then you don't need a router plane.
You just need a block with sandpaper for the dadoes and mortises. My cabinetmaker friends do that if needed. Actually, they seldom do as they use a proper set of dadoes.
Simon
Posts: 2,819
Threads: 1
Joined: Jun 2004
Location: Eagle River Alaska
Thank for every ones input it helps.
Alaskan's for Global Warming
Eagle River AK
Posts: 7,005
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
ruffcutt said:
I'm thinking of getting a router plane. I don't know which brand and if I want an open throat or a closed throat plane.
My main use would be to clean up the bottoms of table saw made dadoes in plywood to insure a consistent depth. Secondary use would be for cleaning up the bottoms of hinge mortises.
As far as brands go I like good tools so I'll pay for a good one.
Tool steel blades and plywood glue are not a happy match. In this case I would use a carbide bit in a power router and not a router plane.
Regards from Perth
Derek