02-15-2016, 07:59 PM
Rehabbing 80's model Vega 1553. Lots of wire brushing, sanding and painting and finally putting it all back together.
But I didn't take enough pix when I started and can't figure out the tailstock screw system.
It retracts the shaft just fine, but when I try to extend it the screw comes out of the back.
Can't find any leftover parts so I'm not sure what the problem is.
Any suggestions?
But I didn't take enough pix when I started and can't figure out the tailstock screw system.
It retracts the shaft just fine, but when I try to extend it the screw comes out of the back.
Can't find any leftover parts so I'm not sure what the problem is.
Any suggestions?
"Truth is a highway leading to freedom" --Kris Kristofferson
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)