03-08-2016, 02:43 PM
I'm "re-purposing" ( at LOML's instruction ) a buffet into a vanity.
Plan was to coat top with Polycrilic water-based poly to avoid fumes, etc inside.
Working on third coat and I'm sanding with 320 wet or dry sandpaper on sanding block between coats and I'm getting gobs of finish rolling up on the paper.
Finish had dried overnight.
I dusted the sandpaper off and wiped off the surface and all was well for a couple of strokes, then it started loading up again.
Is this a problem with Polycrilic or am I doing something wrong???
Plan was to coat top with Polycrilic water-based poly to avoid fumes, etc inside.
Working on third coat and I'm sanding with 320 wet or dry sandpaper on sanding block between coats and I'm getting gobs of finish rolling up on the paper.
Finish had dried overnight.
I dusted the sandpaper off and wiped off the surface and all was well for a couple of strokes, then it started loading up again.
Is this a problem with Polycrilic or am I doing something wrong???
"Truth is a highway leading to freedom" --Kris Kristofferson
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)