Posts: 29,861
Threads: 0
Joined: Jan 2008
Location: Mid-MI
I've never needed to shrink wood.... stretch it, yes.
I think your only option is to get it in a dryer climate and wait.
Mark
I'm no expert, unlike everybody else here - Busdrver
Nah...I like you, young feller...You remind me of my son... Timberwolf 03/27/12
Here's a fact: Benghazi is a Pub Legend... CharlieD 04/19/15
Posts: 29,152
Threads: 1
Joined: Aug 2002
blow dryer set to a lower heat..
gonna take time.........
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
Posts: 1,872
Threads: 0
Joined: Feb 2006
Location: Eastern WA
I guess you could move it back to the basement for a couple months to see if it will revert back to when it was built.
Posts: 800
Threads: 0
Joined: May 2010
Put the box in the oven at around 100 degrees. Check the drawer periodically until it can be removed.
I doubt if the drawer swelled. More likely, it was the box that swelled and captured the drawer.
If I had 8 hours to cut down a tree, I'd do it in 15 minutes with a chainsaw and drink beer the other 7:45 hrs.
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
Hair dryer
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 4,133
Threads: 0
Joined: Oct 2009
Location: Lawrence, KS
JSpill said:
I have a drawer that is stuck in a very thin box. I think the wood from the drawer expanded after it was inserted into the box. The humidity in my basement where the piece was built is so much lower than the humidity in the room where the box has been sitting for the last six months. Is there an easy way I can get the wood to contract so I can get the drawer loose? I don't want to pry it loose. The drawer sides are only 1/8" thick . The entire piece is very fragile, so I would like to avoid the heavy hand tactics I usually apply whenever I am frustrated. Thanks.
Call around to some places that have walk-in freezers. Ask if you can place the object in the freezer for a little while in hopes that the dry air will help lower the moisture content sufficiently to pop the drawer free?
Don't sweat the petty things and don't pet the sweaty things. -- G. Carlin
Posts: 3,545
Threads: 1
Joined: May 2004
Location: Wisconsin
Can you just bring it back to your dry shop? If not, heating is the way to go, since that increases the amount of water the air could hold. At the same amount of water in the air, warmer air will be a lower relative humidity.
The main problem with heating is that it's easy to heat the outside, but what matters is heating the inside, and letting water escape. So it will take a while and may at first briefly make things worse. If you have a free-standing heater to put in a small room with the box, that might work best.
Cooling will diminish the amount of water the air can hold, and some will come out. This diminishes the absolute humidity, but does not provide anywhere for the water from the drawer to go (does not diminish relative humidity). You then need to heat the air from which water has been removed, leading to air at lower relative humidity that can accept water from the wood. A dehumidifier is a device that does this, and would also help.
