▼ 
04-22-2016, 04:02 PM
I purchased an old lathe from my neighbor, it was his fathers that he used in the 1930's. The machine works perfectly, I did add a switch and changed the belt. I purchased a drive center and I was able to do some nice turnings. I want to make the kitchen utensil holder shown in the woodsmith magazine from Feb./ March of 2016. What type of attachment should I get for the headstock to hold the threaded rod that attaches to the mounting disc?
▼
04-22-2016, 05:09 PM
Can you provide a link to the article so we can better understand what you are trying to do?
Mike
"Start off slow and taper off."
04-22-2016, 05:18 PM
Can you post a picture of what you want to do?
From what you describe, it sounds like this is what you're looking for. https://www.woodturnerscatalog.com/p/101...llet+chuck |
|
wanna be woodturner
|
|
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
