I need to find an adapter

[Arlin Eastman]

I have checked a few places for a 1" x 8tpi headstock to 1 1/4" x 8tpi male thread so I can use my 1 1/4 chucks on a 1 x 8 midi lathe.

Help with a link is great

[GeorgeK ®]

Here you go Arlin

linky for adapter

Select size needed

[Arlin Eastman]

Thanks guys. I went there a few hours ago and did not notice the drop down box and it did not show sizes and thought it was a close out.

Arlin

[AHill]

Arlin,

Woodturner's Catalog (CSUSA) has them:

https://www.woodturnerscatalog.com/p/112...le-Adapter

[iclark]

George and Alan already beat me to the link for the one from Craft Supply. I suspect that that one is solid.

If you need one that works with a vacuum chuck or works as an MT2 extension, then try Best Wood Tools. Best Wood Tools is a husband and wife company that supplies first rate products. They occasionally get hard to reach when they get overloaded or when one of them gets sick. I have always had good dealings with them, but they have upset some other folks here. Their booth at the AAW symposium was always so busy when I was in the vendors room that I did not get a chance to chat with them this time.