Woodnet Forums › › Active › Woodworking Power Tools v
Sending and Geting PMs

▼
Arlin Eastman Offline
Honored Veteran Brnz Md w/ValorPrplHrtx2
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
#12
07-19-2016, 07:29 PM
I have had a few people send me PMs and when I went to reply I could not since they did not turn theirs on.

If you wish to send them and receive them go to upper right side of and click on private messages.  When you get there on the bottom left side of the page click on edit Options and when that comes up you will have several boxes to you will have to X. 
Then you will be all set to send and receive PMs

Arlin
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification.  Thank You Everyone.

It is always the right time, to do the right thing.
Find
Reply
▼
LongLook Offline
Member
Posts: 477
Threads: 0
Joined: Apr 2004
#13
07-19-2016, 08:46 PM
Thanks Arlin.  I finally found the right place.  Not exactly obvious without some coaching.
Find
Reply
SheriDi Offline
Member
Posts: 214
Threads: 0
Joined: Jun 2003
#14
07-20-2016, 09:31 AM
I was one of them Arlin.  All good now.
A Veteran is someone who, at one point in their life, wrote a blank check payable to the United States of America for an amount up to and including their life. That is beyond honor.
Find
Reply
BandSawyer Offline
Member
Posts: 370
Threads: 0
Joined: Feb 2007
#15
07-20-2016, 01:13 PM
Arlin, thanks for posting this.

I still do not see pictures in the post however.
Find
Reply
meackerman Offline
Escaped from California...
Posts: 38,525
Threads: 0
Joined: Feb 2002
Location: East Texas
#16
07-20-2016, 01:30 PM
did you turn that option on?
Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick

Mark

Find
Reply
Arlin Eastman Offline
Honored Veteran Brnz Md w/ValorPrplHrtx2
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
#17
07-20-2016, 02:01 PM
(07-19-2016, 08:46 PM)LongLook Wrote: Thanks Arlin.  I finally found the right place.  Not exactly obvious without some coaching.

Yah I spent several hours trying to figure it out and how to post pictures too which is now in the new software forum
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification.  Thank You Everyone.

It is always the right time, to do the right thing.
Find
Reply
Thread Modes
Sending and Geting PMs


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.