WTB: Walnut inserts for chest

[Wild Turkey]

I'm wrapping up a long-term project that got shelved and I've lost some pieces for it.

It's a hope chest based on this design:



The parts I've lost are the inserts for the five panels.  Each insert is about 8"x 12".

I'm looking for some nice burl, etc.  I can resaw if someone has a nice block (or knows where I can find one) or I could use some veneer.

Let me know what you've got and how much for shipping to 42701 (Elizabethtown, KY)

[pinky]

Not sure if these will work for you. I have 6 identical panels that measure over 12" x 15" but over 7/8ths thick. It is particle board veneered with burl on 1 side and plain walnut on the other.

[Wild Turkey]

That look great -- is there any finish on them? I think I could work with 7/8".

PM sent -- ooops, you don't have PMs turned on.

It's the best way to discuss price/shipping, etc.

---

---

iublue, 

turn on your PM's so I can reply to yours

[pinky]

misted with water for photos

[pinky]

How do you turn on PM?
Don't know how it became disabled or how to fix!

[Wild Turkey]

One of the quirks of the software change

Go to home page

about two lines find "User CP"

Click on it and it should take you to your "User Control Panel"

go down a couple of boxes on left side to "Your Profile"

Bottom of that box click on "Edit Options"

Should open "Edit Options" box.

Second header down "Messaging and Notifications"

third box "Receive private messages from other users" should be checked to allow PM's.

Hope this helps!

[pinky]

thanks...

---

Sent myself a message, seems to be up and running. Send me a message on quantity. I'll get them all together and shoot you a price back.

[Wild Turkey]

Found some -- once again the woodnet community comes through