Posts: 2,199
Threads: 1
Joined: Sep 2003
Location: Maryland
I've used DAP, Elmers, Famowood and a couple other brands. Next time anyone needs a wood filler consider Timbermate. It comes in a few colors but you can stain/tint it, sands easy, and if it dries in the container it can be brought back by adding water. Amazon and the wood supply stores all sell it.
Posts: 7,421
Threads: 1
Joined: Sep 2005
That's good to know. Thanks.
No animals were injured or killed in the production of this post.
Posts: 5,119
Threads: 12
Joined: Apr 2009
Location: SoMar
I just use
This stuff.
I keep a tub of it around & mix as needed.
Posts: 14,933
Threads: 0
Joined: Sep 2004
Location: Butler, PA
Timbermate is good stuff!
If you are going down a river at 2 mph and your canoe loses a wheel, how much pancake mix would you need to shingle your roof?
Posts: 511
Threads: 0
Joined: Jun 2010
Adding acetone to many of the canned putties brings them back to life!!
Posts: 1,030
Threads: 3
Joined: Jun 2011
Location: N. Cincy inside the loop
01-05-2017, 11:04 PM
(This post was last modified: 01-05-2017, 11:04 PM by wood2woodknot.)
COOLER (On the last container (tub) I wrapped a piece of plastic sheet over the lid (from a baggie) and put three stout rubber bands around tub to seal out the air.)
_________________________
Another solution is to take a piece of plastic food wrap and cover the material inside the can. Press it down to eliminate any air gaps. Put the lid back on. Just peel back the wrap the next time you need some filler. Then recover.
Posts: 3,390
Threads: 1
Joined: Jan 2002
Handy thread. I have the same problems. Bought the Dap tubestuff last time hoping it would last longer than the tubs but no dice.
-Marc
Posts: 222
Threads: 0
Joined: Jan 2016
Location: s.w. pa
I take A small piece of sponge put acetone on the sponge put in in the can seems to do the trick
south vietnam war collage
Posts: 450
Threads: 0
Joined: Apr 2013
(01-05-2017, 11:04 PM)wood2woodknot Wrote: COOLER (On the last container (tub) I wrapped a piece of plastic sheet over the lid (from a baggie) and put three stout rubber bands around tub to seal out the air.)
_________________________
Another solution is to take a piece of plastic food wrap and cover the material inside the can. Press it down to eliminate any air gaps. Put the lid back on. Just peel back the wrap the next time you need some filler. Then recover.
I'm pretty sure acetone-based wood fillers would melt the plastic wrap. Should work on water-based, if such exists (my current can is acetone-based).
If you're gonna be one, be a Big Red One.
