Posts: 10,717
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
I just turn it off. Kind of messy, but it's easy.
Still Learning,
Allan Hill
Posts: 771
Threads: 0
Joined: Jan 2011
Location: Cincinnati
I have used a large draw knife on chain sawn or riven spindle blanks between centers. It helps to lock the spindle. They are sometimes three sided, at least when I cut them, a draw knife is pretty quick work.
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
If you want to keep the nice looking wood underneath then either air pressure or a pressure washer and help the parts off when they are getting loose.
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 161
Threads: 0
Joined: Jul 2016
Location: Garrett Co. MD. 21550
Yeah , kinda was wanting to keep the rough exterior intact. Got a couple nice half rounds and wanted to turn the inside and leave the outside natural, without bark
Posts: 36,538
Threads: 3
Joined: Nov 2004
Location: RTP, NC
I'll ask... what's wrong with putting it on the lathe and turning it off? Sure it kinda flings itself, but with my face shield that's never been an issue.
Posts: 20,950
Threads: 0
Joined: May 2005
Shouldn't "fling itself" anywhere near a face shield, unless you're cutting above eye level. To expand the thread on wood being the teacher, you're cutting uphill if the waste rises. Wood wants to be cut downhill for both ease and smooth surface.
Depending on the vintage of the "burl", vigorous tapping on the bark with a hard-end mallet should loosen things enough for compressed air. What won't usually comes off with an awl later. Be especially careful of the fissures in the cherry pieces, get glue and/or fill in them as they appear, even if you know that you will have to re-adhere and fill several times. Better that than a flung piece released for insufficient glue.
Better to follow the leader than the pack. Less to step in.
Posts: 5,891
Threads: 0
Joined: Feb 2002
Saw this in a Lyle Jameison video. I use an air chisel like for body or sheet metal work. I think I paid about 7 bucks for mine at HF. It makes quick work of removing bark and easy to boot.
Steve K
Posts: 21,259
Threads: 2
Joined: Mar 2009
Location: IA
(01-31-2017, 04:42 PM)crokett™ Wrote: I'll ask... what's wrong with putting it on the lathe and turning it off? Sure it kinda flings itself, but with my face shield that's never been an issue.
He is wanting to keep the natural effect of the humps and bumps under the bark.
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 36,538
Threads: 3
Joined: Nov 2004
Location: RTP, NC
(01-31-2017, 05:31 PM)MichaelMouse Wrote: Shouldn't "fling itself" anywhere near a face shield, unless you're cutting above eye level.
well my experience with bark is that while I'm cutting on the side of the wood that's moving down towards the tool, the bark on the opposite side is moving up. If the bark peels off as I'm turning, I've had it peel all the way to that back side that's traveling upwards, so as it comes off it gets thrown up, not down.
