03-07-2017, 11:22 AM
▼ ▼
03-07-2017, 11:36 AM
Part of a Belt... Disc sander ????
If it can't kill you it probably ain't no good. Better living through chemicals.
03-07-2017, 12:38 PM
I go with belt sander.
03-07-2017, 12:43 PM
Same here. Or disc. The black 'ways' with adjusting screws would be in/out table adjustment, and the miter slot for moving the work across the face with a miter gauge.
Tom
“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
It attaches to a Delta Unifence rail to extend the miter slot so you can cut a wider piece of wood using the miter gauge on your Unisaw.
I would like to buy it
03-07-2017, 04:54 PM
(This post was last modified: 03-07-2017, 04:55 PM by Dave Diaman.)
I knew someone here would know what it is.
Bandsaw, if you enable your pm's or send me an email we can work out the particulars of the part.
03-07-2017, 04:59 PM
PM's enabled
03-09-2017, 01:50 PM
How wide is the slot?
We used to make one of those for the big Invicta table saws, but the slot was wider than the Unisaw's 3/4".
One day, Chuck Norris ordered two pizzas to go. They went.
03-09-2017, 10:30 PM
Interesting thread as I had one of those miter gauge supports for the Uni-fence back in circa 1983-85 and it was aluminum.
03-10-2017, 05:15 PM
So with one of those I don't have to draw a line and freehand the cut through the table saw?
Whatillthey think of next? |
Mystery Delta Part
|
|
|
Users browsing this thread: 1 Guest(s)