04-19-2017, 08:57 AM
An old friend lives in an old house, circa 1913 (house, not the friend). He had us come out and reseal the finish on his ancient redwood front door. While there, he asked about building a simple mantel piece to cover the original concrete one. So we did.
We glued two long redwood 4x6s together then cut them to the 6 1/2-in width needed. Corners are mitered with grain lines intact and there's a 3/8 lip at the top to cover the seam. This piece runs 84 1/2 inches on the inside and 11 to the wall. Weighs about two pounds. Finish is a brown/white dye combination to match the existing house wood. Rather than sand, we rubbed it down with a fine wire brush to create texture. Our fit was almost too precise but we managed to get it on without resorting to major surgery or gluing.
As simple as this project was, we had some nervous moments when working with the delicate redwood.
We glued two long redwood 4x6s together then cut them to the 6 1/2-in width needed. Corners are mitered with grain lines intact and there's a 3/8 lip at the top to cover the seam. This piece runs 84 1/2 inches on the inside and 11 to the wall. Weighs about two pounds. Finish is a brown/white dye combination to match the existing house wood. Rather than sand, we rubbed it down with a fine wire brush to create texture. Our fit was almost too precise but we managed to get it on without resorting to major surgery or gluing.
As simple as this project was, we had some nervous moments when working with the delicate redwood.
Just because shooting fish in a barrel is easy, that doesn't mean there are some fish that should remain unshot.
www.WestHillsWood.com
www.HOPublishing.com
FACEBOOK: #WoodShopWednesday
www.WestHillsWood.com
www.HOPublishing.com
FACEBOOK: #WoodShopWednesday