Woodnet Forums › › Active › Tool Swap N' Sell v
walnut for bowl turning

▼
thewalnutguy Offline
Member
Posts: 175
Threads: 0
Joined: Dec 2016
#5
05-01-2017, 05:38 PM (This post was last modified: 05-02-2017, 05:01 AM by thewalnutguy.)
Removed a couple of fairly large branches from a black walnut tree. Have half a dozen 3' lengths, 8 to 10 inch diameter, that I'd like to see get put to use. Too small to mill for lumber, but should yield some good bowl turning material. Asking $5 each, three for $10, or the bunch for $15. Obviously this doesn't include shipping. Located east of Forest Lake in Minnesota. Because of the weight - probably over 100 pounds per piece - shipping costs would I'm sure be prohibitive.
Find
Reply
▼
KLaz Offline
Member
Posts: 1,019
Threads: 0
Joined: Feb 2008
#6
05-02-2017, 11:26 AM
You might want to try a local turning club.  Here is a good resource....

https://www.mnwoodturners.com/mwa-chapter/

Most turners source their stock for free from downed trees.  We just had a bad storm blow through Indiana and I've got access to so much silver maple right now, it's not funny.  

Good luck!
"This is our chance, this our lives, this is our planet we're standing on. Use your choice, use your voice, you can save our tomorrows now." - eV
Find
Reply
Thread Modes
walnut for bowl turning


Forum Jump:


Users browsing this thread: 3 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.