Posts: 13,930
Threads: 0
Joined: Apr 2002
Location: Texas
Depending on what they cost you. What replacements cost and if you want to use this opportunity to upgrade
Most of my big tools would cost more than double to replace now after 10 years or so. Selling I would be lucky to get 50%.
Cost of move I would have to see
Most of your stuff really doesn't look that big.
Posts: 1,914
Threads: 0
Joined: Apr 2007
If you can get a storage place in Charlotte, you could load up your stuff (and anything else that could fit) and put the stuff in the storage.
Would not be too expensive. Your stuff is not that heavy, if you have dolly to help you.
If you sell it, you will either have to wait for someone to put comparable used stuff up for sale or rebuy all new. Rebuying all new would proabably cost more than the uhaul..
If you wait around for used.. the used stuff may not be as well taken care of as your stuff, and you might be waiting a long time...
Plus there is the time to meet the seller, drive around to pick it up, etc.. that might be comparable to driving your stuff down to a storage area.
But if you are in temporary housing a long time, storage might get expensive too.
No definite answer, but i would lean torwards keeping them.
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
07-19-2017, 10:02 PM
(This post was last modified: 07-19-2017, 10:04 PM by daddo.)
I don't see anything that heavy either.
Add the weight up and use a trailer the right size and your good to go, or rent a truck with a lift.
Posts: 487
Threads: 0
Joined: Mar 2004
I guess things are not so much heavy as they are awkward to pack securely.
Posts: 805
Threads: 0
Joined: Feb 2003
Location: Land of Enchantment
If it were me I'd lose the jointer and look for a replacement there. They're kind of a PITA to move and take a lot of space in the truck or trailer. The I'd also get rid of anything you've been thinking of upgrading...you have a good excuse now. If you move the bandsaw, be sure to remove the table...the trunions break very easily.
Bob
Posts: 308
Threads: 0
Joined: Jan 2004
Location: richmond va
definitely move. Just moved from boston to VA and moved the whole shop (except sold the drum sander). Packing the shop no different than any other room. And I had all my tools when we got there
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
reading the OP just filled me with dread. Probably mostly because I would hate to move my shop. It probably isn't too bad in the OP's case, but I would have to rent a forklift in any case.
Posts: 18
Threads: 0
Joined: Jul 2017
Posts: 12,879
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
Definitely move the tools you use and like; sell the ones you don't like or don't use and replace on the other end. Moving/packing stuff out of garage shop is not that hard. Just think about getting a few 500+ lb machines out of a basement shop with access only through the house.
John
