#4
The bottom of the glass shower door in our master bath has a piece
of extruded aluminum affixed to it, to deflect water back into the shower.
The house is thirty years old and stuff is wearing out. So, for some things
I have "bought some time" with various fixes....

     The bottom hinge is worn the worst, and allows the door to sag a bit, 
just enough to rub against the tile. I have shimmed it with various bits of
plastic, etc and it will last a bit longer. Fingers crossed. In the middle of
a kitchen remodel and ground floor laminate installation, so don't need 
another problem/expense.

     Today though, the aluminum would NOT stop rubbing. At first I was 
going to use a file and trim off a bit. Deciding that would take a major 
amount of time, my eyes lit on a seldom used "Stanley Surform Plane."
Perfect. Worked a treat. Took longer to vacuum up the shavings off the
floor.

     Odd. But it worked.
Mark Singleton

Bene vivendo est optimum vindictae


The Laws of Physics do not care about your Politics   -  Me
Reply

#5
Pivot hinge??  Add a nylon washer as a spacer. Probably had one years ago.


Al
I turn, therefore I am!
Reply
It may be odd but if it works...


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.