10-29-2017, 02:56 PM
Colleagues: I need another DC line for a TS over the blade dust collection/blade guard.
To run it off the existing 6" TS DC duct, need a hole in the duct then install a saddle tap Y connector on the 6" duct. See:
www.oneida-air.com/inventoryD.asp?item_no=SCOLLECT33
Seems to be rather straight forwarded, but how-in-the-heck do I cut the hole in the existing 6" diameter duct?
Considered a 6" 45 degree Y -- See: https://www.oneida-air.com/inventory..._no=SCOLLECT41 -- but I would need to dismantle the existing duct and blast gate to install it.
Any ideas?
To run it off the existing 6" TS DC duct, need a hole in the duct then install a saddle tap Y connector on the 6" duct. See:
www.oneida-air.com/inventoryD.asp?item_no=SCOLLECT33
Seems to be rather straight forwarded, but how-in-the-heck do I cut the hole in the existing 6" diameter duct?
Considered a 6" 45 degree Y -- See: https://www.oneida-air.com/inventory..._no=SCOLLECT41 -- but I would need to dismantle the existing duct and blast gate to install it.
Any ideas?