Posts: 4,445
Threads: 0
Joined: Jan 2005
(11-07-2017, 11:21 AM)®smpr_fi_mac® Wrote: I have an Incra 1000SE that I love. It's close *enough* when it comes to 90* cuts. But it's off *just enough* that 45* doesn't work--on my latest test cuts, a frame with 25" sides (2.25" wide) *almost* closes completely. But off enough for me to notice.
Do you just calibrate, test, calibrate, test, wash, rinse, repeat until it works? I'm getting frustrated here.
I'm using a Woodpecker square to align it to the blade at 90*. I'm contemplating buying a triangle to set the 45*. Has anybody done this? Do you have a supplier you'd recommend?
I'm also thinking of asking for another 1000SE for Christmas that I'll just leave set at 45*!
I am not familiar with your miter gauge, or any after market miter gauge but have a suggestion that may help.
I will explain how I set a standard miter gauge to a dead 90° and you may be able to do the same with your Incra.
I loosen my miter gauge locking knob just enough so the head can move. Then I turn it upside down and slide it into the miter slot. When the head is snug against the table I tighten the locking knob. That's all there is to it.
I use my band saw table instead of the table saw because the tube the fence rides on is in the way.
I also can set the miter gauge to 22-1/2° and 45° with an MDF scrap with the slots for the gauge routed into it. 90° could also be done on the MDF.
mike
Posts: 22,728
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
Stop at a stationary store and pick up a couple plastic drafting triangles. Not a kids geometry set. Cheap and accurate. Handle with a bit of care and they'll last a lifetime.
Blackhat
Bad experiences come from poor decisions. So do good stories.
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I was at the American Society of Precision Engineers meeting last week, and one of the presenters mentioned that drafting triangles are good to a ridiculous level of accuracy.
Posts: 7,421
Threads: 1
Joined: Sep 2005
A sled will give you your best results for miters.
Screw down an aluminum framing square and use the outer edges to rest the rabbet on. Slice right through the aluminum when you make your first cut. It is guaranteed to be as accurate as the square you mounted.
As long as you cut on the opposite sides of the blade the complimentary angles will always add up to 90 degrees and you will always have tight miters. Even if you are off by 1/2 degree. One side will be 44½ degrees and the other will be 45½ degrees and will make a tight 90 degree miter.
No animals were injured or killed in the production of this post.
Posts: 18,616
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
11-07-2017, 04:29 PM
(This post was last modified: 11-07-2017, 04:29 PM by Phil Thien.)
Don't align it to the blade, align it to the miter slot.
Posts: 27
Threads: 0
Joined: Apr 2017
Down the same path as Phil, did you already make sure your blade is parallel to the slot. When I first used my Incra after moving my TS I found the top/blade out of alignment. I also found to my surprise the Incra was a little off too.