#19
So we just had a new water heater installed with our new furnace ( 50 gallon BW natural gas) and I thought I remembered that it was recommended to turn off and drain the tank once a year?
Does anyone do this and is there any benefit?

Thanks
Reply

#20
I think most water heaters have the fill pipe oriented to stir up the calcium deposits to keep them from building up.  But it does anyway.  I have never emptied mine, but I feel guilty about it.
Reply
#21
It will sure help keep the drain valve from becoming clogged and doesn't hurt.
Turn the power off or set the gas valve at "Pilot" then turn the drain valve on (Incoming cold water source still on) and let it flush (Using a hose of course). The hot water may kill plants or grass so direct it to the weeds or a neighbors yard you don't like.
Reply
#22
I never drain mine.  I simply open the valve and release a few gallons (maybe 5) to keep the valve clear and clear and sediment.
I tried not believing.  That did not work, so now I just believe
Reply
#23
I've always heard that (drain annually) to remove the sediment on the bottom of the tank...but I (and likely 99.9% of everyone else) never have.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#24
The one time I tried, the valve was so plugged with sediment, nothing came out.  
Laugh
Tom

“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Reply
#25
I drain mine. We are also on a well with sediment problems. Our water passes through 4 filters before hitting the water heater and I still drain it. The one I replaced when we moved in was completely clogged and I had to drill it out with a 10" drill to get water to flow from it. I threw out the water treatment equipment because it was so dirty inside. It took a good bit of work to get the water to run clear.
Neil Summers Home Inspections




" What would Fred do?"

... CLETUS











Reply
#26
I try to clear mine every six months. We get rust (iron) on the bottom. I open the valve full blast!  Well, it has a washermachine hose on it that I hold in the slop sink.  Takes about 20 seconds to run clear.


Al
I turn, therefore I am!
Reply
#27
You can clean an electric ones more easily by draining it, removing the bottom element, then take some of that 3/4" black plastic pipe to make an extension to your shop vac hose and get in there and vacuum the deposits out. Otherwise just draining it does get rid of that much if there is any buildup. I've gotten as much as a full hard gallon jug full of calcium from them when I used to clean them years ago.
Reply
#28
(12-16-2017, 09:47 AM)daddo Wrote: The hot water may kill plants or grass so direct it to  a neighbors yard you don't like.


I can't afford that amount of garden hose.
Laugh



When I drain ours, I remove the drain valve and scrap the sediment out. I made a scraper from a 1/8x1/2 piece of flat iron. The end is spoon shaped.
Steve

Mo.



I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24


 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
Draining a water heater annually?


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.