Posts: 1,590
Threads: 0
Joined: Aug 2009
Location: Manassas, VA
12-18-2017, 01:54 PM
(This post was last modified: 12-18-2017, 01:55 PM by FS7.)
(12-18-2017, 10:22 AM)Dave S® Wrote: Looking for some recommendations on how to clean the surface
I have some recycled Douglas Fir that I want to use to frame a mostly antique ceiling tin for my SIL, as a gift for Christmas.
There is a noticeable amount of dust/dirt on the wood, and wanted to scrub it down before she hangs it on the wall. The look I am going for is recycled, distressed wood look, without sanding or needing to use a wire brush
The wood is very thirsty
Available choices I have on hand:
DNA
Mineral Spirits
soap and water
Murphys Oil soap
Thanks for any suggestions
Soap and water, a plastic brush (carpet brush), and a garden hose should do it. A pressure washer might be a little aggressive but would work without soap.
Posts: 437
Threads: 0
Joined: Sep 2003
Location: North of Seattle
I cleaned some up in the shower with a nylon bristle brush and lots of water. I let it dry for a couple weeks before I used it. Stickering it under the couch should be doable if there isn't too much.
Posts: 4,647
Threads: 0
Joined: Jan 2008
12-18-2017, 06:46 PM
(This post was last modified: 12-18-2017, 06:47 PM by tomsteve.)
id start with compressed air. any time ive worked with recycled wood and wanted to keep the look, the less i did the better it looked
Posts: 666
Threads: 0
Joined: Aug 2008
I'm gonna be Captain Obvious here, but just make sure there isn't any metal left over in that wood. Don't want to wreck your blade when crosscutting it!
Near future projects:
-Curly Maple display case
-Jatoba and Quilted Maple dresser
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
Air, soft brush, air, brush, air, etc
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 14,273
Threads: 0
Joined: Jun 2007
Thanks all.
Dave
Posts: 10,773
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
Air, don't use a saftey nozzle either......
Ed
Posts: 2,581
Threads: 0
Joined: Apr 2012
Power wash - depending on how hard you want to go after it.
Posts: 507
Threads: 0
Joined: Jul 2013
Check out a Porter cable restorer. Hand held brush sander.
