▼ 
When upside down, if I don't positively control the base when releasing the locking trigger, this leg comes out of the base.
I've had this router base for fifteen years or so, but it has seen *very* little use. Is this normal? 
Semper fi,
Brad ▼
02-08-2018, 08:37 PM
You know, I think I may have figured it out. Is there supposed to be some sort of o-ring in that groove at the end of the rod that provides enough friction to keep it in place?
Semper fi,
Brad ▼ 
02-08-2018, 09:01 PM
(02-08-2018, 08:37 PM)®smpr_fi_mac® Wrote: You know, I think I may have figured it out. Is there supposed to be some sort of o-ring in that groove at the end of the rod that provides enough friction to keep it in place? I believe it is a snap ring, not an 'O' ring. The 1619, the one I have, shows one on the top side, but I don't see one on the bottom, in the diagram. I am not going to tear it apart just to look. https://www.ereplacementparts.com/bosch-..._3229.html
I tried not believing. That did not work, so now I just believe
|
|
Faulty Bosch plunge router base?
|
|
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
