02-26-2018, 08:21 AM
I haven't done much woodworking or turning over the past few years due to illness. I am feeling better now and would like to turn a pepper mill and salt mill for one of my daughters. To that end I bought 8' kits and some really nice figured walnut and maple. The walnut was imported from Turkey and is 2" square. I know this will be a bit thin, but it was the largest piece that I could get. I will have to be careful when turning it round, not to loose much of the diameter.
Anyway, to my question: How long should the top and bottom be for 8" kits?
TIA, Joe
Anyway, to my question: How long should the top and bottom be for 8" kits?
TIA, Joe
"We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm"
Winston Churchill
Winston Churchill