Posts: 13,006
Threads: 0
Joined: Mar 2003
(04-17-2018, 12:44 PM)®smpr_fi_mac® Wrote: Over many months I've asked about resawing on my bandsaw and have been given lots of advice. This week I *finally* tried it for the first time. I put a new Timberwolf 1/2" resawing blade on my 14" Delta with 3/4hp motor, mounted the stock fence, and went at it.
The stock was 8" tall, 5/4, jointed/planed just enough to make both sides flat and parallel. It worked great, without a hitch.
Lessons learned:
- 3/4hp is adequate, but can get bogged down if I push it too hard. I'm still hunting for a 1.5hp motor, though.
- I need to fab up a taller fence.
- I need to use a featherboard to ensure a straighter cut.
So, thanks to you guys for helping me out! Now I have bookmatched panels for the cradle I'm building.
I clamp a tall fence to my bandsaw fence.
Al
I turn, therefore I am!
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
+1 on clamping a tall fence board on.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
Michael, I'm left handed, so I put the fence on the right side of the blade. I'll need to do the opposite if I wish to use a feather board in the track on the table. Which is fine with me, as the feather board will provide the positive pressure against the (next time taller) fence. Then I'll just need to push it through.
I didn't get any drift on the blade. It tracked straight through. The only flaws in the surface were from me not maintaining pressure against the fence equally as I cut.
Semper fi,
Brad
