06-13-2018, 10:13 PM
I know that the LN honing guide was built around their products. Anyone have any idea how well Blue Spruce paring or dovetail chisels will work in it?
Thanks
Thanks
▼ ▼ 
06-14-2018, 06:29 AM
06-14-2018, 07:18 AM
(This post was last modified: 06-14-2018, 07:19 AM by Belle City Woodworking.)
I know Barr Chisels won't fit in the LN Honing Guide.
Formerly known as John's Woodshop
06-14-2018, 08:14 AM
Philip1231- Good to know on the Blue spruce appreciate it.
Belle City Woodworking- a shame but good to know as well. They are too thick? I know the slicks would be a bit long? ▼
06-14-2018, 11:54 AM
(This post was last modified: 06-14-2018, 11:55 AM by Belle City Woodworking.)
(06-14-2018, 08:14 AM)mongo Wrote: Philip1231- Good to know on the Blue spruce appreciate it. They taper the slightest little bit and they are very thick blades. I have begun to use a Veritas MKII honing guide for the wider chisels and the Narrow Chisel guide for the others. Shame I had to get these just for these chisel but over the years I believe it will be worth the investment. The project I worked on today the Barr Chisels made short work of it. John
Formerly known as John's Woodshop
06-14-2018, 11:25 AM
I had Blue Spruce paring chisels and have the LN honing guide. The 1/4" Blue Spruce did not fit the LN guide. The 1/2" did perfectly. The BS 1/4" was a hair too thin for the guide. The guide's lips closed against each other leaving the 1/4" chisel loose.
06-17-2018, 12:59 PM
Mongo,
L-N have a pair of jaws for small chisels and I suspect these will hold the BS chisel. Best wishes David ▼
06-23-2018, 08:18 PM
David thank you very much for the reply. Apologies for my slow reply was transfered at work this last week and things have been a zoo.
Are you overal happy with the guide? Thank you, Brad
06-27-2018, 12:29 PM
Brad,
I certainly am. It is a beautiful piece of engineering. David |
|
Blue spruce Chisels in Lie Neisen honing guide ?
|
|
|
|
|
Users browsing this thread: 2 Guest(s)