07-07-2018, 12:40 PM
This first one I call "Swirl" The biggest challenge was figuring out the matching radius on each segment.
The second one is made from scraps from the first one. In the first one, each piece is cut on a taper and the cutoffs were used to make the second one.
All comments, both positive and negative are welcome.
The second one is made from scraps from the first one. In the first one, each piece is cut on a taper and the cutoffs were used to make the second one.
All comments, both positive and negative are welcome.
There is a fine line between woodworking and insanity - sometimes I am not sure which side of the line I am on.